Is this possible?

[ Follow Ups ] [ Post Followup ] [ PanoCube/PanoLink message board ]

Posted by Cees de Jonge (84.104.232.241) on February 21, 2008 at 12:42:40:

Hello Andrew

Is it possible to convert the six cubes back to one tif or jpeg file? I have to make two QTVR versions of each panorama. One high and one low res.

I convert the panorama file, generated bij PTgui to six cubics with Panocube Plus. Then i retouche the nadir and zenith cubes and convert them to a high res QTVR. When i downscale the tif cubes to a smaller size and convert them again with Panocube plus i get a low res QTVR with lines between the six cubes.
So i have to downscale the panorama file, convert to six smaller cubes and retouche them again to get low res QTVR without lines..

Is there a workaround?

Kind regards

Cees

Follow Ups:

Re: Is this possible? Andrew Jakowleff 13:04:13 02/21/08 (0)

Post a Followup:

[ Follow Ups ] [ Post Followup ] [ PanoCube/PanoLink message board ]

Name:
E-Mail:
Subject:
Comments:	: Hello Andrew : Is it possible to convert the six cubes back to one tif or jpeg file? I have to make two QTVR versions of each panorama. One high and one low res. : I convert the panorama file, generated bij PTgui to six cubics with Panocube Plus. Then i retouche the nadir and zenith cubes and convert them to a high res QTVR. When i downscale the tif cubes to a smaller size and convert them again with Panocube plus i get a low res QTVR with lines between the six cubes. : So i have to downscale the panorama file, convert to six smaller cubes and retouche them again to get low res QTVR without lines.. : Is there a workaround? : Kind regards : Cees