PanoCube fails launching PTStitcher using 4NT instead of CMD

Posted by XA (84.63.101.110) on August 01, 2006 at 01:50:58:

PanoCube fails launching PTStitcher using 4NT instead of CMD.

4NT shows "4NT: Unknown command "-"" as error message and just displays the prompt. Why do you invoke PTStitcher via the shell (as given by COMSPEC)?

A little debugging shows, you invoke the shell using a command line like "- /Cstart /w ...". The leading "-" confuses 4NT -- what's its purpose?

Sincerely,
-- XA

Name:
E-Mail:
Subject:
Comments:	: PanoCube fails launching PTStitcher using 4NT instead of CMD. : 4NT shows "4NT: Unknown command "-"" as error message and just displays the prompt. Why do you invoke PTStitcher via the shell (as given by COMSPEC)? : A little debugging shows, you invoke the shell using a command line like "- /Cstart /w ...". The leading "-" confuses 4NT -- what's its purpose? : Sincerely, : -- XA